Trek Pivot Interchangeable Lid: Swap Straw to Chug and Clean
By Stylish Water Bottles, Travel Mugs,Food Storage, and Backpacks - ... | Published: 2026-10-31
Category: How-to Guides
Learn how to switch your Trek Pivot lid from straw to chug mode, clean both parts safely, and keep the seal leak-proof with a simple routine.
Quick answer
To switch your Trek Pivot lid from straw to chug, open the lid, press the release tab to pop out the current sipping piece, and click the other piece into the same opening until it seats flush. Clean both pieces and the lid body by hand with warm soapy water after each use, then air-dry fully before reassembling.
Why the two-piece design changes your cleaning routine
Because the sipping component comes out of the lid body, you can clean the straw or chug piece separately instead of scrubbing around a fixed spout. That matters most for the straw piece, where liquid sits inside the tube and can leave residue if you only rinse the outside.
The double-walled lid body insulates, but that also means you should not soak it or put it in the dishwasher unless the manufacturer says otherwise. Hand-washing the body and fully removing the sipping piece gives you the best chance of avoiding trapped moisture and odors.
When swapping makes sense and when it does not
Swap to the chug piece for fast drinking during workouts or commutes, and to the straw piece for desk or car use where tilting the bottle is awkward. The swap takes seconds, so you can change mode between activities rather than buying a second lid.
One limitation: the lid is leak-proof only when closed. If you toss the bottle in a bag with the sipping piece open, expect drips regardless of which piece is installed. Also check that the sipping piece is fully seated before you close the lid, because a partially clicked piece can prevent the lid from sealing.
How to swap and clean the Trek Pivot lid
- Open the lid and remove the current sipping piece: Flip the lid open, then press the release tab or pinch the base of the straw or chug piece and pull it straight out of the lid body. Do not twist hard; the piece is designed to pop out. If it resists, check for a small locking tab before pulling harder.
- Install the other sipping piece: Align the base of the new piece with the opening and press down until it clicks or seats flush with the lid surface. Tug gently to confirm it is secure. A piece that sits proud of the lid surface is not fully seated and may leak.
- Wash both pieces and the lid body by hand: Separate the sipping pieces from the lid body. Wash all parts in warm water with mild dish soap, using a small bottle brush for the straw tube and the crevice around the lid opening. Skip the dishwasher unless the manufacturer explicitly allows it; heat can warp seals.
- Rinse and air-dry completely: Rinse under running water, shake off excess, and leave all pieces apart on a drying rack until fully dry, especially inside the straw tube. Reassembling while damp traps moisture and can cause a musty smell.
- Reassemble and test the seal: Click your preferred sipping piece back into the lid body, close the lid, and give the bottle a gentle shake over a sink to check for leaks before packing it. If it leaks, remove and reseat the piece; a crooked piece is the usual cause.
Product facts
- Trek Pivot Interchangeable Straw/Chug Lid: The lid includes two interchangeable sipping pieces—straw and chug—that swap within the same lid body. You can change drinking style without buying or carrying a second lid.
Trek Pivot Interchangeable Straw/Chug Lid - Trek Pivot Interchangeable Straw/Chug Lid: The lid is double-walled to help hold drink temperature. Hand-wash and avoid soaking the body so the insulation stays effective.
- Trek Pivot Interchangeable Straw/Chug Lid: The lid is leak-proof when the sipping piece is in the closed position. Always close the lid before packing it, even with the chug piece installed.
